Filter
Top Products
SYSTEM PROGRAMMING - Menu 1
SYSTEM PROGRAMMING - Menu 1
PAGE 8
PAGE 9
80 SERIES
80 SERIES
INSTALL MANUAL
INSTALL MANUAL
QUICK VIEW PROGRAMMING
TACH / TACHLESS LEARNING
AUTO TACH/ TACHLESS LEARNING
Horn/ Siren will chip to confirm that
the Tach/ Tachless has been programmed.
Start the vehicle with
the ignition key.
2 CHIRPS
To Tach/ Tachless Learn the system simply start the vehicle with the ignition key. To confirm that
a proper Tach signal has been programmed the system will chirp the Horn/ Siren and flash the
park lights two times. If the tach wire is not connected the park lights will flash and the horn will
chirp 4 times to indicate Tachless Mode. If the Tach is not learned when the start button is
pressed the park lights will flash 7 times.
***The system must be Tach Learned before remote starting***
MANUAL TACH/ TACHLESS LEARNING
Start the vehicle with
the ignition key.
SYSTEM PROGRAMMING - Menu 1
***For vehicles with no 12volt START wire***
Many new GM vehicles do not have a 12volt start wire that the remote start is connected to. To
Tach learn the system Press and Hold the brake pedal, Start the vehicle with the key then
press and release the program button then hold for 5 seconds. To confirm that a proper Tach
signal has been programmed the system will chirp the Horn/ Siren and flash the park lights two
times. If the tach wire is not connected the park lights will flash and the horn will chirp 4 times to
indicate Tachless Mode. If the Tach is not learned when the start button is pressed the park lights
will flash 7 times.
***The system must be Tach Learned before remote starting***
* If Tach does not learn check for proper connection on the starter wire, ignition wire and
at the Tach connection. If the connections are good, reset the system and try again.
-For best results connect the Tach wire to a fuel injector wire.
* If the vehicle does not start when the remote starter is activated, the park lights will
flash a diagnostic code. (See Diagnostic Chart).
**If the vehicle still does not start, check all connections and check for a factory installed
Anti-Theft system. If the Anti-Theft prevents the vehicle from starting the remote start will
flash the park lights 7 times. The system does not have to be Tach learned if this
happens, simply start the vehicle with the key and let it run for 5 seconds then turn off.
TACH NOTES
BRAKE
Hold the
brake
2ND
IGNITION
SETTING #
LED
FLASHES
SETTING
DESCRIPTION
OPTION 1
1 CHIRP
OPTION 2
2 CHIRPS
OPTION 3
3 CHIRPS
1
2
3
4
5
6
SELECTABLE
RELAY
2ND
STARTER
2ND ACCESSORY
SPECIAL DOOR
LOCK OPTIONS
UNLOCK BEFORE / LOCK
AFTER START
LOCK AFTER STARTER
SHUT OFF
NO ADDITIONAL PULSES
GAS / DIESEL MODE
NEG GLOW PLUG / 30 SEC
DELAY
15 SECOND DELAY GAS / POSITIVE GLOW PLUG
RE-ARM OPTIONS PULSE WITH LOCK
PULSE AFTER START
(DEFROST / SEAT)
PULSE WITH LOCK & AFTER
SHUTDOWN
RUNTIME 4 MINUTE RUNTIME
PRESS BUTTON ONCE TO
START
45 MINUTE RUNTIME 15 MINUTE RUNTIME
REMOTE START
ACTIVATION
PRESS BUTTON TWICE TO
START
PROGRAM MODE 3
PROGRAM MODE 4
PROGRAM MODE 3 - see page 21 for detailed instructions
PROGRAM MODE 4 - see page 23 for detailed instructions
SYSTEM PROGRAMMING - Menu 1
SYSTEM PROGRAMMING - Menu 1
AUTO TACH / TACHLESS
SETTING #
LED FLASHES
SETTING
DESCRIPTION
OPTION 1
1 CHIRP
OPTION 2
2 CHIRPS
OPTION 3
3 CHIRPS
1
2
3
4
TACH OPTIONS HYBRID MODE
ADJUST FOR OVER-
CRANK
INCREASES TACH SETTING
BY 10%
ADJUST FOR UNDER-
CRANK
DECREASE TACH SETTING
BY 10%
TACH WAIT SETTINGS 300ms TACH CHECK DELAY 750ms TACH CHECK DELAY NO TACH CHECK DELAY
When the installation is complete start the vehicle with the key.
For more information see the following page for
special notes regarding the Tach Learning procedure.
To confirm that a proper
Tach signal has been programmed the system will chirp the Horn/ Siren and flash the park
lights two times. If the tach wire is not connected the park lights will flash and the horn will
chirp 4 times to indicate Tachless Mode.
TACH LEARNING
7
LEDS FLASH WHEN
LOCKED/ ARMED
LED FLASHES
LEDS DO NOT FLASH
WHEN LOCKED/ ARMED
4 CHIRPS
Horn/ Siren will chip to confirm
that the Tach/ Tachless has been
programmed.
2 CHIRPS
4 CHIRPS