Filter
Top Products
SYSTEM PROGRAMMING - Menu 1
SYSTEM PROGRAMMING - Menu 1
PAGE 6
PAGE 7
80 SERIES
80 SERIES
INSTALL MANUAL
INSTALL MANUAL
QUICK VIEW PROGRAMMING
QUICK VIEW PROGRAMMING
Press Lock
Press Unlock
Press Start
Press #
MENU 1 MENU 2 MENU 3 MENU 4
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and release the Program Switch 1 time. (Horn/ Siren will chip to confirm program
mode entered)
3 - Select the Program Menu by pressing...
ENTERING PROGRAM MODE
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and RELEASE the Program Switch 1 time.
(Horn/ Siren will chip to confirm program mode has been entered)
3 - Press and HOLD the Program Switch for 5 seconds or until the Horn/ Siren Chirps 3 times.
4 - Turn the ignition key OFF to exit.
SYSTEM RESET
TRANSMITTER PROGRAMMING
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2) Press and HOLD the Program Switch
(The Horn/ Siren will chirp 1 time, CONTINUE to HOLD)
**If the Horn/ Siren does not chirp turn the key off, then repeat step 1**
3) Continue to HOLD the Program Switch and the Horn/ Siren will chirp 5 times.
4) Press the LOCK BUTTON on each of the remote’s to be programmed.
*Pause for about 1 second between programming of each remote
System can accept up to a maximum of 4 remote’s
5) The park lights will flash once and the Horn/ Siren will chirp once each time a new code is
learned.
6) Release the Program switch and turn Ignition OFF.
4 - Press and Release the Program Switch to advance through the settings.
(Confirmed by Horn/ Siren chirps & LED flashes)
5 - Press and hold the Program Switch to change the setting.
(Confirmed by Horn/ Siren Chirps)
6 - To exit Program Mode, turn the key off.
(Confirmed by Long Horn/ Siren Chirp)
IGNITION AUTO-LOCKS
DISABLED
SETTING #
LED FLASHES
SETTING
DESCRIPTION
OPTION 1
1 CHIRP
OPTION 2
2 CHIRPS
OPTION 3
3 CHIRPS
1
2
3
4
5
6
7
IGNITION
AUTO-LOCK
IGNITION AUTO-LOCK /
UNLOCK
IGNITION AUTO-LOCK
ONLY
HORN / SIREN
SETTINGS
HORN / SIREN CHIRPS
DISABLED
HORN/SIREN CHIRPS
ENABLED
DOOR LOCK PULSE
OPTIONS
DOUBLE UNLOCK &
SINGLE LOCK
DOUBLE LOCK & SINGLE
UNLOCK
SINGLE LOCK & SINGLE
UNLOCK
DOOR LOCK / UNLOCK
PULSES
0.25 SEC PULSES 3 SEC PULSES 0.75 SEC PULSES
AUX CHANNEL 1
(-) IGNITION
CAR FINDER ON # *
2ND UNLOCK
DOME LIGHT
CAR FINDER ON # *
(-) ACCESSORY OUTPUT
# AUX 1 OUTPUT
WITH DISARM*
AUX CHANNEL 2
AUX OUTPUT (2&3)
WITH DISARM
PASSIVE DOOR LOCKS
PASSIVE DOOR LOCKS
DISABLED
PASSIVE DOOR LOCKS
ENABLED
8
PASSIVE ARMING/
PASSIVE ST. KILL
FULL PASSIVE ARMING
ENABLED
PASSIVE SAFETY REARM
ENABLED
9
ALARM
SHOCK / AUX SENSOR
INTERNAL SHOCK
DISABLED
AUX SENSOR DISABLED BOTH SENSORS ENABLED
ACTIVE ARMING ONLY
PROGRAM MODE 1
SETTING #
LED
FLASHES
SETTING
DESCRIPTION
OPTION 1
1 CHIRP
OPTION 2
2 CHIRPS
OPTION 3
3 CHIRPS
1
2
3
4
ALARM
5
M-UNITS
VALET SETTINGS
SECURE VALET
15 SECONDS
STANDARD VALET
PARK-LIGHT OUTPUT 30 SECONDS ON DISARM NORMAL OPERATION
HORN TIMING 5MS OUTPUT 50MS OUTPUT
10MS OUTPUT
* 30ms ON ALARM
SIREN OPTIONS 30 SECOND DURATION PULSED FOR HORN 60 SECOND DURATION
RESERVATION MODE
PRESS BRAKE 2 TIMES TO
ACTIVATE
PRESS # TO ACTIVATE
PROGRAM MODE 2
PROGRAM MODE 1 - see page 16 for detailed instructions
PROGRAM MODE 2 - see page 19 for detailed instructions
SYSTEM PROGRAMMING - Menu 1
SYSTEM PROGRAMMING - Menu 1
* Car Finder Mode and the Auxiliary 1 output are not available on 2way models.