Filter
Top Products
SYSTEM PROGRAMMING - Menu 1
SYSTEM PROGRAMMING - Menu 1
PAGE 10
PAGE 11
80 SERIES
80 SERIES
INSTALL MANUAL
INSTALL MANUAL
SYSTEM WIRING DETAILS
SYSTEM WIRING DETAILS
PIN-1 YELLOW Starter Output-This wire will test 0V when the key is off, in the Accessory position and when
the Ignition is in the on position. The starter wire is 12volts during the start/ crank position only.
PIN-2 GREEN Heater/Acc Output-This wire will test 0V when key is off, 12volts in the ACC and iIGN
positions and off during start/ crank position.
PIN-3 RED 12volt Input(30amp)- This input supplies the 12volt power for the Ignition, Park Lights and
the Selectable outputs.
PIN-4 RED 12volt Input(30amp)- This input supplies the 12volt power for the Accessory and Starter
outputs.
PIN-5 BLUE Ignition Output- This wire will test 0V in the off and Accessory positions the switch to12volts
in the Ignition and Start positions.
PIN-6 WHITE Selectable Output - 2nd Ignition, Accessory or Start output. Programmable. (See Page 21).
Note: This output does not switch to default when the system is reset.
PIN-1 BROWN (+) Siren / (-) Horn (Programmable)- Connect this wire to the Brown or Red wire on the
SIREN (Alarm Models) This output can be programmed to act as an additional HORN output (+)
PIN-2 ORANGE Starter Kill/ Anti-Grind- This wire can be connected to an additional relay to disable the
start circuit when the lock button is pressed. The output will also stay on when remote started, this will prevent
the starter motor from being re-engaged while the vehicle is running.
PIN-3 WHITE Jumper Selectable Park Light Output (+ or -)- Connect to the vehicles positive park light
wire or change the jumper and connect to the vehicle negative park light wire. The default position of the jumper
is Positive Park light Output.
PIN-4 BLACK System Ground Input- Connect to chassis ground.
WHITE
SYSTEM GROUND INPUT
JUMPER SELECTABLE PARK LIGHT OUTPUT (+ OR -)
(+) SIREN/ HORN OUTPUT (-)
STARTER-KILL/ ANTI-GRIND OUTPUT
BLACK
ORANGE
BROWN
6-PIN CONNECTOR
4-PIN CONNECTOR
BLUEOUTPUT TO ACTIVATE IGNITION CIRCUIT
WHITE*SELECTABLE OUTPUT (DEFAULT SECOND IGNITION)
RED30A HIGH CURRENT 12VOLT INPUT
YELLOWOUTPUT TO ACTIVATE START CIRCUIT
RED30A HIGH CURRENT 12VOLT INPUT
GREENOUTPUT TO ACTIVATE ACCESSORY/ HEATER CIRCUIT
PIN 1- GREEN Wire- Negative Lock Output
Connect to lock wire from the switch on vehicles with a negative type switch. **LOW CURRENT ONLY**
PIN 2- 12volt Output for Door Lock Module
This output will supply 12volts for a plug-in type door lock module. Do not use this input to power-up relays
**LOW CURRENT ONLY**
PIN 3- BLUE Wire- Negative Unlock Output
Connect to lock wire from the switch on vehicles with a negative type switch. **LOW CURRENT ONLY**
***SEE PAGE 24 FOR RELAY DIAGRAMS***
BLUENEGATIVE OUTPUT FOR UNLOCK
12+ OUTPUT FOR DOOR LOCK MODULE
GREENNEGATIVE OUTPUT FOR UNLOCK
4 PIN AUXILIARY SENSOR CONNECTOR
FOR MORE DETAILED INFORMATION ON PROGRAMMING, WIRING DIAGRAMS, DOOR LOCK
CONFIGURATION AND OTHER INFORMATION, PLEASE VISIT
WWW.ULTRASTARTERS.COM/DIAGRAMS