Filter
Top Products
ALARM MODELS ONLY
3 CHIRPS
Press & HOLD Lock + Unlock buttons at the same time
Press & HOLD Lock + Unlock buttons at the same time
Each time the lock button is pressed and released the sensitivity will
INCREASE by 1 level. This is confirmed by a series of park light flashes
& SIREN Chirps
Each time the unlock button is pressed and released the sensitivity will
DECREASE by 1 level. This is confirmed by a series of park light flashes
& SIREN Chirps
Continue to hold the buttons for 3-5 seconds until the SIREN
Chirps 3 times
1 - ENTER SHOCK SENSOR ADJUSTMENT MODE
2 - ADJUSTING THE SHOCK SENSOR
3 - EXITING SENSOR ADJUSTMENT MODE
+
+
(Note: System will Arm or Disarm via silent arming prior to entering adjustment mode)
(1 Flash / Chirp is the least sensitive setting & 10 Flashes / Chirps is the most
sensitive)
(1 Flash / Chirp is the least sensitive setting & 10 Flashes / Chirps is the most
sensitive)
(NOTE: Shock Sensor Adjustment Mode has an auto time out of 8 seconds)
If the system has been triggered (shock sensor, door input..), the siren will sound for
approximately 60 seconds. Press and release the lock or unlock button to silence the siren
(the system will remain armed). Press the unlock button to disarm the system. The siren
and park lights will flash three times to indicate the system had been triggered.
SYSTEM PROGRAMMING - Menu 1
PAGE 27
80 SERIES
INSTALL MANUAL
QUICK VIEW OPERATIONS
SYSTEM PROGRAMMING - Menu 1
PAGE 26
80 SERIES
INSTALL MANUAL
SHOCK SENSOR SETTINGS
SYSTEM PROGRAMMING - Menu 1
QUICK VIEW OPERATION CHART
1 SECOND
3 SECONDS
1 SECOND (PANIC OR ALARM)
1
1
OFF
LOCK / ARM ALARM
ACTIVATE PANIC
ALARM/ PANIC OFF
1 SECOND
1 SECOND (PANIC OR ALARM)
HOLD FOR 3 SECONDS
2
OFF
2 + 1
UNLOCK / DISARM
ALARM/ PANIC OFF
UNLOCK + TRUNK
1 SECOND
1 SECOND WHEN RUNNING
3 SECONDS W/ REMOTE START
1
1
2
REMOTE START
EXTENDED RUNTIME
SHUTDOWN
HOLD FOR 3 SECONDS
PRESS AND RELEASE
5 LONG
STATUS
CAR FINDER MODE
STATUS CHECK ON 2WAY
BUTTON LENGTH OF PRESS
CHIRPS /
FLASHES
SYSTEM OPERATION
** PLEASE SEE OWNERS GUIDE FOR DETAILED OPERATIONS AND FEATURES
SERVICE MODE / EMERGENCY OVERRIDE
TO AVOID SERIOUS INJURY, this remote start system must be set into Service Mode
before any under hood servicing is started. Service Mode will prevent the vehicle from
starting while the vehicle is being serviced. It is the sole responsibility of the vehicle’s
owner to place the system into Service Mode. The manufacture accepts no
responsibility for accidental starting of the vehicle while the vehicle is being serviced.
ACTIVATING / DEACTIVATING VALET MODE / EMERGENCY OVERRIDE
Turn the Ignition Key ON
(Leaving the key ON)
Press and hold the Valet switch for 8 to 15 seconds
(Time depends on "Valet Settings" Program Option)
REMOTE START AND ALARM DEACTIVATED
REMOTE START AND ALARM ACTIVATED
5 CHIRPS = OFF
2 CHIRPS = ON