Ultra Start 2280 Automobile Alarm User Manual


 
SYSTEM PROGRAMMING - Menu 1
PAGE 29
80 SERIES
INSTALL MANUAL
MANUAL TRANSMISSION
TRANSMITTER PROGRAMMING
ENTERING REMOTE PROGRAM MODE
The system can lean up to 4 different remote’s. Each remote to be used MUST be
programmed together during the same sequence. For security, when a new remote is
programmed all previous remote’s are deleted. Please see remote operation chart for
information on using Second Car / Pad Lock Operations.
HOLD the program switch, the HORN will chirp ONCE and the park lights will
turn on. (If the HORN does not chirp repeat step 1) CONTINUE TO HOLD until
the HORN chirps 5 times
Press & Release LOCK button on 1st Remote to be
Programmed for Normal Operation If remote(s) are to be
programmed for "PADLOCK" (AM 1way Only) skip and goto step 6
Press & Release BUTTON 4 on Remote to be Programmed
for 2ND CAR OR PAD LOCK
HORN will Chirp 1 time to confirm remote has been
programmed (If the HORN does not chirp press button again)
HORN will Chirp 1 time to confirm remote has been
programmed (If the HORN does not chirp press button again)
PROGRAMMING REMOTE’S
Cycle the Ignition Key - ON/OFF ON/OFF ON
(Leaving the key ON)
Turn ignition key OFF to exit remote program mode when
all required remote’s have been programmed.
1 chirp confirms program mode entered followed by
5 chirps confirming transmitter program mode
1 -
2 -
3 -
4 -
6 -
5 -
7 -
8 -
REPEAT STEP 4 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR NORMAL OPERATION
REPEAT STEP 6 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR 2ND CAR / PADLOCK OPERATION
SYSTEM PROGRAMMING - Menu 1
PAGE 28
80 SERIES
INSTALL MANUAL
TRANSMITTER PROGRAMMING
Manual transmission remote starters must be set into Reservation Mode before the
remote starter will activate. The activation type of Reservation Mode is determined when
the system is installed.
Auto Reservation Mode (Default)
1- While the vehicle is running, place into neutral and apply the park brake.
2*- Press and release the brake pedal twice. The park lights will flash twice,
the SIREN or HORN (opt.) will chirp twice and the doors will unlock (opt.).
3-Turn the ignition key off and the vehicle will continue running.
4**- Within 30 seconds, exit the vehicle and close all the doors. The vehicle will then shut off .
Manual Reservation Mode (Optional)
1- While the vehicle is running with the key, place transmission into neutral
and apply the park brake.
2- Press and release the START button. The park lights will flash twice, the SIREN or HORN
(opt.) will chirp twice and the doors will unlock (opt.).
3- Turn the ignition key off and the vehicle will continue running.
4- Exit the vehicle and close all the doors.
5**- Press and hold the START button for 3 seconds, the vehicle will then shut off.
* If the park lights do not flash and stay on or the SIREN (HORN optional) chirps a third time,
repeat Step 2.
** If the vehicle has dome light delay, the vehicle may stay running until the dome light turns off.
This is normally no longer than 30 seconds.
**TEST RESERVATION MODE**
1) Press the start button on the remote without setting the Reservation Mode. The park
lights should flash 4 times without starting the vehicle. If the vehicle starts THE WRONG
REMOTE STARTER HAS BEEN INSTALLED!!!
2) Set the Reservation Mode then remote start the vehicle. Shut off with the remote wait
10 seconds then open the passenger door. Press Start on the remote and Reservation
Mode should be cancelled. (4 flashes) if not, check for proper door pin connections.
*****FOR SAFETY REASONS ALL DOOR PINS INCLUDING THE REAR HATCH MUST BE
CONNECTED.******
RESERVATION MODE
To program 2nd car operation on 2way models enter transmitter program mode and turn the # icon on
then program the transmitter to the vehicle. If the # icon is on the remote is in 2nd car operation.