Communications Setup and Operation Teledyne API - T100 UV Fluorescence SO2 Analyzer
152
To assign or reset the status flag bit assignments, access the COMMUNICATIONS
Menu (refer to Figure 5-13), then press:
SETUP X. HESSEN STATUS FLAGS
<SET SET> EDIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID INET HESN COM1 COM2 EXIT
SETUP X. PMT DET WARNING: 0002
PREV NEXT EDIT PRNT EXIT
Repeat pressing SET> until …
SETUP X. SYSTEM RESET: 0000
PREV NEXT EDIT PRNT EXIT
Press <CH and
CH> to move the
[ ] cursor left
and right along
the bit string.
Repeat pressing NEXT or PREV until the desired
message flag is displayed. Refer to Table 7-15.
For Example …
ENTR accepts the new
settings
EXIT ignores the new
settin
s
SETUP X. SYSTEM RESET: [0]000
<CH CH> [0] ENTR EXIT
Press [?]repeatedly to cycle through the available character set: 0-9
Note: Values of A-F can also be set but are meaningless.
Figure 6-10: COMM – Status Flag Bit Assignment
6.6.2.7. INSTRUMENT ID
Each instrument on a Hessen Protocol network must have a unique identifier (ID
number). Refer to Section 5.7.1 for information and to customize the ID of each.
