Unit 4: Printer Configuration
GL408-412e Operator’s Manual
4-61
A 1 to 32 character, case-sensitive string that identifies the Extended Service Set Identification
(ESS_ID) network with which the unit is affiliated. ESS_ID is also referred to as NET_ID.
This character string is broken up into three sets. This menu allows a psecific set to be selected
and the idenitification entered into the menu screen that follows.
These characters may be alphanumeric, symbols, or spaces.
This menu allows the determination of if the SSID Name is too be reset.
Minimum Tranfer Rate. Allows the minimum speed at which the wireless option will accept a
connection to be set in millions of bits per second.
• Auto-negociate - factory default. Automatically selects.
• 1Mb/sec. - 1 million bits per second.
• 2Mb/sec. - 2 million bits per second.
• 5.5Mb/sec. - 5.5 million bits per second.
Allows the wireless channel to be selected for the device to communicate.
• Default - factory default. the interface card detects the correct channel to communicate with
the Access Point in infrastructure mode.
• Select Channel - the allowable range is 1 to 15.
Antenna Diversity. Allows the type of antenna to be used to be selected.
• Diverse - factory default. Select to use the antenna with the best reception.
• Primary - select to use the primary antenna on the server.
• Auxiliary - select to use the auxiliary antenna on the server.
Allows the preamble length in tranfer packets to be selected. Preamble is the delay needed
between packets of data. The preamble selection is dependent on the network.
• Default - factory default. The wireless option automatically determines the length.
• Short - preamble of 96 microseconds. This is appropriate for most newer networks.
• Long - preamble of 192 microseconds. This is for legacy systems that do not support the
higher preamble rates.
Power Management. This menu allows the power-save and sleep modes to be set. The value set
wil be in milliseconds. If set to zero, the power-save mode will be disabled.
The allowable range is 0 to 1000 ms., and the factory default is 0 ms..
Allows the transmission power to be set as a percentage of full power capabilities.
The allowable range is 0 to 100%, and the factory default is 100%.
WIRELESS LOCAL AREA NETWORK (WLAN) INTERFACE MODE (TABLE 4-9)
MENU DESCRIPTION
SSID Name
SSID Name (01 – 15)
SSID Name (16 – 30)
SSID Name (31 – 32)
WLAN SETTING
Reset SSID Name
Min Xfer Rate
Auto-negociable*
