Unit 4: Printer Configuration
GL408-412e Operator’s Manual
4-78
Defines which media mode TGL will operate on receipt of a ‘D’ (strip mode) from the issue mode
parameter in the XS command. Any of the supported media modes can be selected. When
Ignore is selected, TGL will use the issue mode as configured through Media Handling under the
Media Control menu.
The factory default is Tear-Off.
AR Pre-Feed Command. Allows the selection of how the printer will respond to command for a
paper pre-feed (AR).
• Process - factory default. Sent commands from the host take precedence.
• Ignore - printer settings take precedence. The paper will not pre-feed.
AX Fine Adjustment Command. Allows the selection of how the printer will respond to command
for a position fine adjustment (AX).
• Process - factory default. Sent commands from the host take precedence.
• Ignore - printer settings take precedence. The paper will not fine adjust.
This menu is used to define the alignment of the image on the page.
• Center - factory default. Evenly spaced using the page width set in the configuration.
• Left - aligned to the left side. When printing in the Portrait mode, the image’s top will exit the
printer first. Inverted Protrait mode, the image’s bottom will exit the printer first.
Allows for fine adjustment of print the resolution used to convert coordinates of page elements
(barcodes, font fields, graphic images,lines, boxes). The coordinates received from the host are
in 1/10 millimeters and are converted to engine resolution (203 or 300 dpi).
In cases where the printed image length is incorrect, the vertical resolution value TGL uses for
calculations can be fine adjusted between -100 and +100. Negative values result in a lower dpi
value and thus a shorter image. This adjustment does not affect the size of fonts and barcodes,
only the coordinates.
The factory default is 0.
Allows the selection of how the printer will respond to command to the WS command for status
responses from the printer.
• Disable - factory default. Will not process commands.
• Enable - will process commands.
IGL EMULATION MODE (TABLE 4-14)
MENU DESCRIPTION
Permits entry into the EMULATION Mode.
Allows the specific emulation to be selected or if the Select option is chosen, the menu to follow
will contain a list of emulation options available.
TGL EMULATION MODE (TABLE 4-13)
MENU DESCRIPTION
XS Media ‘D’ Act
Tear-Off*
AX Fine Adj. CMD
Process*
