Unit 4: Printer Configuration
GL408-412e Operator’s Manual
4-76
Is the menu selection screen for the EMULATION Mode.
Allows the selection of how the printer will respond to non-TGL format text to either be printed or
ignored.
• Yes - factory default. All data is parsed by the TGL emulation. Non-TGL data is absorbed.
• No - all data is is passed to the LP+ emulation.
For information on setting the LP+ Text Mode through the host data stream, refer to the TGL
Programming Reference manual.
Determines where and how errors will be displayed.
• Disable - factory default. Errors display only on the printer’s LCD.
• Enable - errors are printed and displayed on the printer’s LCD.
Allows the character set to be selected.
The options are PC-850, PC-8, or 8859-2 Latin 2. The factory default is PC-850.
Determines if a zero numeral will be printed with a diagonal slash.
• Disable - factory default. The zero character does not have a slash.
• Enable - the zero character is overlayed with a slash.
Determines if an imaged will be scaled according to the printer’s print resolution.
• Disable - factory default. Scaling will not take place, resulting in images that are 2% larger
than images printed on the TEC printer. The image will maintain the correct proportions and
result in faster printing.
• Enable - images are scaled from TEC printer resolution (306 dpi) to the resolution of the TGL
printer (300 dpi).
TGL EMULATION MODE (TABLE 4-13)
MENU DESCRIPTION
TGL Setup
Active
Print Errors
Character Set
Slash Zero
Image Scale
SFCC Select
EURO Symbol
Speed CMDs
AY Intensity CMD
U1/U2 Move CMDs
XS Sensor Param
XS Media ‘C’ Act
XS Media ‘D’ Act
AR Pre-Feed CMD
AX Fine Adj. CMD
Page alignment
Vert. DPI Adjust
Status Response
