Configuration and Management
26 1/1551-CRH 102 167 Uen Rev A 2006-09-07
IP address range to
The last IP address in a range of IP addresses
that can be assigned to the LAN clients.
Max Lease Time [sec]
The IP address lease time, specified in
seconds:
min: 60
max: 2147483647
To disable the DHCP server, clear the Enable DHCP server check box.
If you for some reason want to configure your connected devices with static
addresses, make sure that the addresses are outside the DHCP server IP
address range.
To change the range of available addresses, change the IP addresses in
the IP address range from and IP address range to fields.
Note: The DHCP server IP address range has to be on the same subnet
as the Ericsson W20 LAN IP address. The IP address range must
not include the Ericsson W20 IP address.
In the Maximum lease time [sec] field, enter the time (in seconds) you
want the LAN device to lease the IP address before it is reassigned.
Click Apply to save the settings.
2.5.2 Traffic Statistics
The following information is displayed in the Traffic Statistics section on
the LAN page:
Transmitted
The total size (and number) of transmitted data
packets on the LAN.
Received
The total size (and number) of received data packets
on the LAN.
Error
The number of invalid data packets.
Overruns
The number of packet loss due to too many
incoming data packets.
Dropped
The number of dropped data packets.
Note: The data size and packet counters have the upper limits of 4 GiB
and 2
32
packets (more than 4 billion packets). When these limits
have been reached, the counters wrap around to zero.
