Configuration and Management
22 1/1551-CRH 102 167 Uen Rev A 2006-09-07
Note: The data size and packet counters have the upper limits of 4 GiB
and 2
32
packets (more than 4 billion packets). When these limits
have been reached, the counters wrap around to zero.
2.4.2 Authentication
Internet access requires authentication of the Ericsson W20. Depending on
the current Internet service setup, the authentication requests may differ.
Your service provider provides the Ericsson W20 SIM card and details
needed for authentication.
The following authentication details may be required:
PIN
The Personal Identification Number, which is used for
SIM authentication.
Remember my
PIN
If enabled, SIM authentication is automatic and you
will not have to enter the PIN in case of a system
restart.
APN (3G)
The 3G Access Point Name, which is a reference to
the UMTS Internet access point on the service
provider’s network. The APN usually has the format
<name.service_provider.country>.
APN (2G)
The 2G Access Point Name, which is a reference to
the GPRS/EDGE Internet access point on the service
provider’s network. The APN usually has the format
<name.service_provider.country>.
PPP user name
The Point-to-Point Protocol Internet mode user name,
which is used for user authentication.
PPP password
The Point-to-Point Protocol Internet mode password,
which is used for user authentication.
If you have not used the Configuration Wizard for configuration of Internet
access, or authentication is required because of a reset to factory default
configuration, fill in the PIN, APN (2G), APN (3G), PPP user name, and
PPP password fields. For automatic SIM authentication in case of a
system restart, select the Remember my PIN check box. Click Apply .
Note: Only enter details that you have received from your service
provider and leave other fields empty. If the PIN is locked
message is displayed, no PIN is required.
