Figure 29. Replacing the internal USB key
1. USB memory key 2. USB memory key connector
Next steps
1. Follow the procedure listed in After working inside your system.
2. While booting, press <F2> to enter the System Setup and verify that the USB key is detected by the
system.
Expansion cards and expansion-card risers (optional)
NOTE: A missing or an unsupported expansion-card riser logs an SEL event. It does not prevent
your system from powering on and no BIOS POST message or F1/F2 pause is displayed.
Expansion card installation guidelines
Your system supports Generation 1, Generation 2, and Generation 3 cards. The following table provides
riser configurations for R430 systems:
Table 3. Expansion card slots available on the expansion-card riser
Expansion-
card riser
PCIe slot on the
expansion-card
riser
Processor
connection
Height Length Link
width
Slot width
PCIE_G3_X16 1 Processor 1 Half Height Half
Length
x16 x16
2 Processor 1 Half Height Half
Length
x16 x16
PCIE_G3_X8 1 Processor 1 Full Height Half
Length
x8 x16
79
