Filter
Top Products
4-6
FRONT WHEEL AND BRAKE DISCS
CHAS
NOTE:
NOTE:
Brake disc bolt
Front: 18 Nm (1.8 mSkg, 13 ftSlb)
Rear: 30 Nm (3.0 mSg, 22 ftSlb)
LOCTITE
d. Measure the brake disc deflection.
e. If out of specification, repeat the adjustment
steps until the brake disc deflection is within
specification.
f. If the brake disc deflection cannot be brought
within specification, replace the brake disc.
EAS00545
INSTALLING THE FRONT WHEEL
The following procedure applies to both brake
discs.
1. Lubricate:
Swheel axle
Soil seal lips
Recommended lubricant
Lithium-soap-based grease
2. Lift the wheel up between the fork legs.
3. Insert the wheel axle.
Install the tire with the mark
1
pointing in the
direction of wheel rotation.
4. Lower the front wheel so that it is on the
ground.
5. Install the brake calipers by installing the
bolts, and then tightening them to the speci-
fied torque.
Make sure that there is enough space between
the brake pads before installing the brake cali-
pers onto the brake discs.
Brake caliper bolt:
40 Nm (4.0 mSkg, 29 ftSlb)
6. Install the brake hose holders by installing
the bolts and nuts.
7. Secure the wheel axle by installing the axle
bolt, and then tightening it to the specified
torque.
Axle bolt:
91 Nm (9.1 mSkg, 66 ftSlb)