Filter
Top Products
PERIODIC MAINTENANCE AND MINOR REPAIR
6-30
6
2. Loosen the locknut on each side of
the swingarm.
3. To tighten the drive belt, turn the
adjusting bolt on each side of the
swingarm in direction
a
. To loos-
en the drive belt, turn the adjusting
bolt on each side of the swingarm
in direction
b
, and then push the
rear wheel forward.
NOTE:
_
Using the alignment marks on each
side of the swingarm, make sure that
both belt pullers are in the same posi-
tion for proper wheel alignment.
_
ECA00025
CAUTION:
_
Improper drive belt slack will over-
load the engine. Keep the drive belt
slack within the specified range.
_
4. Tighten the locknuts, the axle nut
and the brake caliper bracket bolt
to the specified torques.
1. Brake caliper bracket bolt 1. Locknut (× 2)
2. Drive belt slack adjusting bolt (× 2)
3. Alignment marks
Tightening torques:
Locknut:
11.6 ft·lbf (1.6 m·kgf, 16 Nm)
Axle nut:
108.5 ft·lbf (15.0 m·kgf, 150 Nm)
Brake caliper bracket bolt:
21.7 ft·lbf (3.0 m·kgf, 30 Nm)