Filter
Top Products
INSTRUMENT AND CONTROL FUNCTIONS
3-6
3
Self diagnosis device
This model is equipped with a self-di-
agnosis device for various electrical cir-
cuits.
If any of those circuits are defective,
the clock display will indicate a two-dig-
it error code (e.g., 11, 12, 13).
If the clock display indicates such an
error code, note the code number, and
then have a Yamaha dealer check the
motorcycle.
ECA00122
CAUTION:
_
If the clock display indicates an er-
ror code, the motorcycle should be
checked as soon as possible in or-
der to avoid engine damage.
_
EAU00118
Handlebar switches
EAU03888
Dimmer switch “ / ”
Set this switch to “ ” for the high
beam and to “ ” for the low beam.
EAU04218
Turn signal switch “ / ”
To signal a right-hand turn, push this
switch to “ ”. To signal a left-hand
turn, push this switch to “ ”. When
released, the switch returns to the cen-
ter position.
Since this model is equipped with a
self-canceling system, the turn signal
lights will self-cancel after the motor-
cycle has traveled both about 490 ft
(150 m) and for approximately 15 sec-
onds. However, the turn signal lights
can also be canceled manually by
pushing the switch in after it has re-
turned to the center position.
NOTE:
_
The self-canceling system only oper-
ates when the motorcycle is moving, so
that the turn signal lights will not self-
cancel while you are stopped at an in-
tersection.
_
EAU00129
Horn switch “ ”
Press this switch to sound the horn.
1. Dimmer switch “ / ”
2. Turn signal switch “ / ”
3. Horn switch “ ”