Filter
Top Products
PRE-OPERATION CHECKS
4-2
4
NOTE:
_
Pre-operation checks should be made each time the motorcycle is used. Such an inspection can be accomplished in a very
short time; and the added safety it assures is more than worth the time involved.
_
EWA00033
WARNING
_
If any item in the Pre-operation check list is not working properly, have it inspected and repaired before operating
the motorcycle.
_
Control cables
•Make sure that operation is smooth.
• Lubricate if necessary.
6-31
Wheels and tires
•Check for damage.
• Check tire condition and tread depth.
• Check air pressure.
• Correct if necessary.
6-19–6-22
Brake and shift pedals
•Make sure that operation is smooth.
• Lubricate pedal pivoting points if necessary.
6-31
Brake and clutch levers
•Make sure that operation is smooth.
• Lubricate lever pivoting points if necessary.
6-32
Sidestand
•Make sure that operation is smooth.
• Lubricate pivot if necessary.
6-33
Chassis fasteners
•Make sure that all nuts, bolts and screws are properly tightened.
•Tighten if necessary.
—
Instruments, lights, signals
and switches
•Check operation.
• Correct if necessary.
—
Sidestand switch
•Check operation of ignition circuit cut-off system.
• If system is defective, have Yamaha dealer check vehicle.
3-15
ITEM CHECKS PAGE