Filter
Top Products
137
Starting and driving
Load on the roof
– Fit the guide pins into the guide holes (1).
– Carefully lower the bracket on the other
side to the roof.
– Screw the knob up a bit.
– Press the knob against the roof bracket
and catch the hook in the roof bracket
under the roof rail.
– Screw the load carrier in place.
– Fit the guide pins of the other brackets
into the guide holes.
– Screw the load carrier in place.
– Check that the hook is properly secured
in the roof bracket.
– Tighten the knobs alternately until the
carrier feels secure.
– Replace the cover.
– Check that the roof rack is properly
secured.
– Check the knobs regularly to see that they
are properly tightened.
Load carriers’ location – roof
rails
Make sure that the load carriers are placed
the right way round on the roof rails. The load
carriers can be placed anywhere along the
roof rail.
When driving without a roof load, the front
load carrier should be positioned about
50 mm in front of the centre roof mounting
and the rear load carrier positioned about
35 mm in front of the rear roof mounting (illus-
trated above). This is to keep wind noise to a
minimum.