10
Safety
Seatbelts
Tensioning the hip strap. The belt must be
positioned low down.
Always use a seatbelt
Heavy braking can have serious conse-
quences if the seatbelts are not used. Ensure
that all passengers use their seatbelts. Other-
wise, rear seat passengers may be thrown
forward against the backs of the front seats in
the event of a collision.
Putting on a seatbelt:
– Pull the belt out slowly and secure it by
pressing the buckle into the lock. A loud
"click" indicates that the belt has locked.
Taking off a seatbelt:
– Press the red lock button and let the belt
retract. If the belt does not retract fully,
feed the belt in by hand so that it does not
hang lose.
The belt locks and cannot be withdrawn:
• If it is pulled out too quickly.
• During braking and acceleration.
• If the car leans heavily.
It is important that the belt lies against the
body so it can provide maximum protection.
Do not lean the backrest too far back. The
seatbelt is designed to protect in a normal
seating position.
Keep the following in mind:
• Do not use clips or anything else that can
prevent the belt from fitting properly.
• Ensure the belt is not twisted or caught
on anything.
• The hip strap must be positioned low
down (not over the abdomen).
• Tension the hip strap over the lap by
pulling the diagonal shoulder belt as illus-
trated.
WARNING!
Each belt is intended for one person only.
WARNING!
The seatbelts and airbags interact. If a
seatbelt is not used or is used incorrectly,
this may diminish the protection provided
by the airbag in the event of a collision.
WARNING!
Never modify or repair the seatbelts your-
self. Contact an authorised Volvo work-
shop.
If the belt has been subjected to a major
load, such as in a collision, the entire belt
must be replaced. Some of the protective
characteristics of the belt may have been
lost, even if it appears to be undamaged.
Replace the seatbelt if the belt is worn or
damaged. The new seatbelt must be type-
approved and intended for installation in
the same position as the replaced belt.