Filter
Top Products
2006 VOLVO V70
train HomeLink®, continue to hold the HomeLink® button. At the same time, repeatedly press and hold
your hand-held transmitter's button at two-second intervals until HomeLink® has learned your
transmitter's code. The HomeLink® indicator light will flash first slowly, and then rapidly to indicate
that the button has been successfully programmed.
Determining if your garage door uses a rolling code
Determine, in one of the following ways, if your garage door uses a rolling code system and is
manufactured after 1996:
● Refer to the garage door opener owner's manual for verification.
● If your hand-held transmitter appears to program the HomeLink® Universal Transceiver but the
programmed button does not activate the garage door, your garage door opener may have a rolling code.
● Press the programmed HomeLink® button. If the garage door opener has the rolling code feature, the
HomeLink® indicator light flashes rapidly and then glows steadily after approximately 2 seconds.
To train a rolling code garage door opener, follow these instructions after programming the desired
transceiver button according to "Programming the transceiver." The help of a second person may make
training easier.
1. Locate the training button on the garage door opener motor head unit. The location and color of the
training button may vary. If you encounter difficulty, refer to the garage door opener owner's manual or
call toll-free 1-800-355-3515 (Internet:
www.HomeLink.com).
2. Press the "training" button on the garage door opener motor head unit until the "training" light comes
on.
3. Press and release the programmed HomeLink® button. Press and release the programmed
HomeLink® button a second time to complete the training process. Some garage door openers may
require you to do this procedure a third time to complete the training.
The programmed button on your HomeLink® Universal Transceiver should now operate your garage
door opener. The original hand-held transmitter can also be used, as desired, to operate the garage door.
The remaining two HomeLink® buttons can be programmed in the same way. In the event of any
problems in programming the HomeLink® Universal Transceiver, call toll-free 1-800-355-3515
(Internet:
www.HomeLink.com).
Operating the HomeLink® Universal Transceiver
Once programmed, the HomeLink® Universal Transceiver can be used in place of your hand-held
transmitters.
To operate, the key must be turned to the "accessory" position (II) or the engine must be running. Press
file:///K|/ownersdocs/2006/2006_V70/06v70_11.htm (3 of 5)12/30/2006 4:50:37 PM