Filter
Top Products
2006 VOLVO V70
3. High beam flash
4. Toggle between high and low beams, Home Safe lighting
Turn signals
When turning
Move the lever as far up or down as possible (to position 2) to start the turn signals. The turn signals will
be cancelled automatically by the movement of the steering wheel, or the lever can be returned to its
initial position by hand.
When changing lanes
The driver can flash the turn signals by moving the turn signal lever up or down to position 1 and
releasing it. The turn signals will flash until the lever has been released.
NOTE: If the turn signal indicator flashes faster than normal, check for a burned-out turn signal bulb.
High/low beam headlights
Continuous high beams
● Turn the ignition key to position II.
● With the light switch (1) in position ., (see page 35) pull the turn signal lever toward the steering
wheel (position 4) to toggle between high and low beams (this also applies on models equipped with the
optional Bi-Xenon headlights).
High beam flash
● Turn the ignition key to position II.
● Pull the turn signal lever to position 3. The high beams will remain on until the lever is released.
Home safe lighting
When you leave your car at night, you can make use of the home safe lighting function to illuminate the
area in front of the car.
● Remove the key from the ignition switch.
● Pull the direction indicator lever as far as possible towards the steering wheel (to position 4) and
release it.
● Exit the car and lock the doors. The headlights and parking lights will illuminate and remain on for
30*, 60 or 90 seconds. The time interval can be changed by an authorized Volvo retailer.
* Factory setting
pg. 38 Right-side steering wheel lever
file:///K|/ownersdocs/2006/2006_V70/06v70_02b.htm (7 of 20)12/30/2006 4:50:22 PM