Filter
Top Products
2006 VOLVO V70
Steel grid
Steel grid (accessory)
To remove the steel grid:
1. Fold down the entire rear seat backrest.
2. Press and turn the knobs on opposite ends of the steel grid with a torx screwdriver until the marks on
the knobs are aligned with red dots (1 in the inset illustration above).
3. The steel grid is spring loaded. Push the grid toward the left (driver's) side of the car to release it from
the retaining bracket on the opposite side. Keep the grid straight when performing this step so that it
does not become wedged in place.
4 Pull the opposite end of the grid out the retaining bracket.
WARNING!
When the steel grid is installed, make sure that the marks on the knobs are aligned with the green dots
(2 in the inset illustration above), which indicates that the grid is locked in place.
To install the steel grid, perform the steps in the reverse order.
file:///K|/ownersdocs/2006/2006_V70/06v70_04b.htm (12 of 21)12/30/2006 4:50:25 PM