Volvo V70 Automobile User Manual


 
2006 VOLVO V70
WARNING!
Do not remove coolant expansion tank cap. The coolant will be extremely hot.
If necessary, see
page 154 for information on checking and topping-up the coolant level.
CAUTION: Drive slowly and carefully if going through standing water (i.e. flooded roadways, etc.).
Damage to the engine could result if excess water is drawn in through the air intake system. Never drive
the vehicle in water deeper than 1 foot (300 mm). See the flood warning on page 5.
WARNING!
Driving with the tailgate open: Driving with the tailgate open could mean that poisonous exhaust
gases enter the passenger compartment.
If the tailgate must be kept open for any reason, proceed as follows:
- Close the windows.
- Set the ventilation system to air flow to floor, windshield and side windows and blower control to its
highest setting.
Floor mats: An extra mat on the driver's floor can cause the accelerator pedal to catch. Check that
the movement of the accelerator pedal is not impeded. Not more than one protective floor covering
may be used at one time.
Electrical system
When replacing the battery or when carrying out work involving the electrical system, the following
should be observed:
A battery connection to the wrong terminal will damage the electrical system. Be sure to connect the
positive battery cable to the positive battery terminal and the negative battery cable to the negative
battery terminal.
If booster batteries are used for starting, they must be properly connected to minimize the risk of the
electrical system being damaged. For correct connection, see "Jump starting" section.
Never disconnect the battery circuit (for example, to replace the battery) while the engine is running,
as this may damage the generator. Always make sure that all the battery connections are properly
cleaned and tightened.
If any electrical welding work is performed on the vehicle, the battery's ground lead (negative cable)
and all the connecting cables of the generator must be disconnected and the welder cables placed as near
file:///K|/ownersdocs/2006/2006_V70/06v70_06a.htm (21 of 25)12/30/2006 4:50:28 PM