Filter
Top Products
2006 VOLVO V70
1. If necessary, remove the cotter pin from the locking bolt and slide the locking bolt out of the hitch
assembly.
2. Slide the ball holder into the hitch assembly.
3. Align the hole in the ball holder with the one in the hitch assembly.
4. Slide the locking bolt through the hitch assembly/ball holder.
5. Insert the cotter pin in the hole at the end of the locking bolt.
Removing the ball holder
1. Remove the cotter pin from the locking bolt and slide the locking bolt out of the ball holder/hitch
assembly.
2. Pull the ball holder out of the hitch assembly.
NOTE: A cover for the hitch assembly can be purchased from your Volvo retailer.
pg. 109 Jump starting
Jump starting
Follow these instructions to jump start your car's dead battery or to jump start another car's dead battery
using your car. Although your car's battery is located under the floor of the cargo area, jumper cables
should be connected in the engine compartment, to the points shown in the illustrations.
If the 12-volt auxiliary battery to be used is in another car, check that the cars are not touching to prevent
premature completion of a negative circuit. Be sure to follow jump starting instructions provided for the
other vehicle.
To jump start your car:
● Switch off the ignition.
● First connect the auxiliary battery positive (+) terminal (1) to the positive (+) terminal in your car's
engine compartment (2), located under a small black plastic cover attached to the fuse box cover,
marked with a "+" sign. Remove the cover on the main fuse box if necessary to access this terminal. See
file:///K|/ownersdocs/2006/2006_V70/06v70_06b.htm (6 of 14)12/30/2006 4:50:29 PM