Filter
Top Products
1993 Volvo 940
Remove the expansion tank cap. Open the drain cock on the right side of the engine block and disconnect the
lower radiator hose.
Fill coolant through the expansion tank. The heater controls should be fully open when draining and filling.
Add coolant until the level is up to the MAX mark or slightly above.
Start the engine and run until hot. Check the cooling system connections for tightness. Also re-check the
coolant level.
Capacity: See "Specifications"
Coolant: Volvo Genuine Coolant/Antifreeze only
CAUTION!
The cooling system must always be kept filled to correct level.
If it is not kept filled, there can be high local temperatures in the engine which could result in
damage.
Different types of anti-freeze/coolant may not be mixed.
WARNING: If the engine is warm and you are going to top up coolant, unscrew the cap slowly in order to
allow any excess pressure to escape.
NOTE: Do not top up with water only. Water by itself reduces the rust-protective and anti-freeze qualities of
the coolant and has a lower boiling point. It can also cause damage to the cooling system if it should freeze.
pg. 8:15 Lubrication
No. Lubricating hint Lubricant
1 Hood lock and latch Oil
file:///K|/ownersdocs/1993/1993_940/93940_8_13.html (3 of 6)12/30/2006 9:44:36 AM