Filter
Top Products
1993 Volvo 940
Clean the contact surfaces on the wheel and hub. Lift the wheel and place it on the hub. Make sure that
you align the wheel with the guide stud on the wheel hub prior to installation. Install the wheel nuts
crosswise and tighten lightly. The bevelled side of the nuts should face the wheel. Lower the vehicle to
the ground and alternately tighten the nuts to 63 lbs. (85 Nm). Install the wheel cap.
Some models have a hub cap that extends to the wheel rim. The valve symbol on the inside of the hub
cap should be installed toward the valve. After driving for a short time, a gap of approximately 0.2" (5
mm) will develop between the wheel cover and the rim. This is normal.
Contents | Top of Page
file:///K|/ownersdocs/1993/1993_940/93940_6_1.html (4 of 4)12/30/2006 9:44:31 AM