Filter
Top Products
11
16
CHARGING SYSTEMS
9. Install brush holder.
Important: Length of brush retainer screws are
different. Install as shown, Fig. 42.
Screw “A”: 11.5 mm
Screw “B”: 9.0 mm
Fig. 42 – Install Brush Holder
A
11.5 mm
B
9.0 mm
10. Install rear cover and three screws, Fig. 43.
a. Torque screws to 3.0 Nm (25 in. lbs.).
11. Install insulator and nut.
a. Torque nut to 4.0 Nm (35 in. lbs.).
Fig. 43 – Install Cover
Torque drive pulley using the following procedure,
Fig. 44.
1. Hold nut with tool #19491.
2. With torque wrench, turn 10 mm deep socket
COUNTERCLOCKWISE.
a. Torque to 70.0 Nm (50 ft. lbs.).
Fig. 44 – Torque Pulley
TURN WRENCH
COUNTERCLOCK-
WISE
HOLD NUT