Vanguard 432447 Automobile Parts User Manual


 
11
11
CHARGING SYSTEMS
DISASSEMBLE ALTERNATOR
1. Remove pulley nut using tool #19491 and 10 mm
deep socket as shown in Fig. 22.
a. Remove pulley and spacer.
Replace pulley if damaged or worn.
Fig. 22 – Remove Pulley
2. Remove nut and insulator at “B” terminal.
3. Remove three screws and brush cover, Fig. 23.
Fig. 23 – Remove Rear Cover
B
TERMINAL
4. Remove two screws, then brush retainer
assembly, Fig. 24.
Important: Length of brush retainer screws are
different. Do not mix.
Screw “A”: 11.5 mm
Screw “B”: 9.0 mm
Fig. 24 – Remove Brush Retainer
A
11.5 mm
B
9.0 mm
5. Remove three screws and regulator, Fig. 25.
Fig. 25 – Remove Regulator