Filter
Top Products
6
3
CYLINDER BLOCK INSPECTION AND REPAIR
2. Install camshaft bearing, Fig. 7.
a. Use camshaft bearing driver, Tool #19422.
NOTE: Notch on camshaft bearing must face out.
Be sure oil hole in bearing is aligned with
oil hole in cylinder block.
Fig. 7 – Installing Cam Bearing
REPLACING CAMSHAFT PLUG
1. Remove rear camshaft plug, Fig. 8.
a. Use a wood dowel or brass rod to prevent
damage to camshaft bearing.
Fig. 8 – Removing Camshaft Plug
2. Install new camshaft plug using camshaft bearing
driver, Tool #19422.
a. Install camshaft plug flush with cylinder block,
Fig. 9.
Fig. 9 – Installing Camshaft Plug
If cylinder block is being resized, the following
parts should be removed so that cylinder block
may be thoroughly cleaned.
1. Remove oil pressure switch, water gallery plug
and oil filter adapter, Fig. 10.
Fig. 10 – Removing Oil Pressure Switch
ADAPTER
PLUG
SWITCH