Filter
Top Products
If you do it yourself, be sure to follow all the
instructions here, or you could get a false reading
on the dipstick.
Notice: Too much or too little fluid can damage
the transaxle. Too much can mean that some of
the fluid could come out and fall on hot engine
or exhaust system parts, starting a fire. Too
little fluid could cause the transaxle to overheat.
Be sure to get an accurate reading if you check
the transaxle fluid.
Wait at least 30 minutes before checking the
transaxle fluid level if you have been driving:
• When outside temperatures are above
90°F (32°C).
• At high speed for quite a while.
• In heavy traffic — especially in hot weather.
• While pulling a trailer.
To get the right reading, the fluid should be at
normal operating temperature, which is 180°F to
200°F (82°C to 93°C).
Get the vehicle warmed up by driving about
15 miles (24 km) when outside temperatures are
above 50°F (10°C). If it is colder than 50°F (10°C),
you may have to drive longer.
Checking the Fluid Level
Prepare the vehicle as follows:
1. Park the vehicle on a level place. Keep the
engine running.
2. With the parking brake applied, place the shift
lever in PARK (P).
3. With your foot on the brake pedal, move the
shift lever through each gear, pausing for
about three seconds in each one. Then,
position the shift lever in PARK (P).
4. Let the engine run at idle for three to
five minutes.
Then, without shutting off the engine, follow
these steps:
The transaxle fluid
dipstick handle has
this symbol on it, and
is located near the front
of the engine
compartment.
320