Filter
Top Products
You will have two and one-half minutes to
complete Step 4. Now press one button on the
Universal Home Remote for each switch
setting as follows:
• If you wrote “Left,” press the left button in
the vehicle.
• If you wrote “Right,” press the right button
in the vehicle.
• If you wrote “Middle,” press the middle
button in the vehicle.
5. After entering all of the switch positions,
again, firmly press and release all three
buttons at the same time. The indicator lights
will turn on.
6. Press and hold the button you would like to
use to control the garage door until the
garage door moves. The indicator light above
the selected button should slowly blink.
You may need to hold the button from five to
55 seconds.
7. Immediately release the button when the
garage door moves. The indicator light will
blink rapidly until programming is complete.
8. Press and release the same button again.
The garage door should move, confirming
that programming is successful and complete.
To program another Fixed Code device such as an
additional garage door opener, a security device,
or home automation device, repeat Steps 1-8,
choosing a different button in Step 6 than what you
used for the garage door opener.
Using Universal Home Remote
Press and hold the appropriate button for at least
half of a second. The indicator light will come
on while the signal is being transmitted.
Reprogramming Universal Home
Remote Buttons
You can reprogram any of the three buttons by
repeating the instructions.
151