Filter
Top Products
User Guide 29
Fault finding
All Raymarine products are designed to provide many years of trouble-free
operation. We also put them through comprehensive testing and quality
assurance procedures before shipping.
If a fault occurs with your S1000, use the fault finding tables in this section
to help identify the problem and provide a solution. If you cannot resolve the
problem yourself, refer to the product support information.
TOO FAST TO FISH Fishing patterns will only operate at speeds below
15kts. Check your speed.
WAYPOINT ADVANCE You have arrived at a waypoint on your route. The
autopilot is now requesting permission to turn onto
the next leg, press PILOT to accept.
SYMPTOM POSSIBLE CAUSE and SOLUTION
Display is blank No power – press standby to power up the S100
or change the batteries.
Autopilot not responding. Drive the boat for 30 seconds at above 2.5kts and
retry.
Check autopilot connections.
Check GPS is switched on and connected.
Boat turns slowly and takes a
long time to come onto course
Rudder gain too low. Complete AutoLearn or
increase gain setting.
Boat overshoots when turning
onto a new course
Rudder gain too high. Complete AutoLearn or
decrease gain setting.
Position information not
received
Navigator not transmitting the correct position
data.
The pilot will not auto advance
to the next waypoint.
No bearing to waypoint information received from
the navigator.
Instruments powered from
SeaTalk will not power up
Check connections
Check fuses
ALARM MESSAGE POSSIBLE CAUSE and SOLUTION