Filter
Top Products
32 Ra
y
marine S1000 Auto
p
ilot
To Register a handset
In the DEALER menu, at
REGISTRATION, press PILOT.
If the S100 is not registered, the
display will read NOT REGISTERED.
Press > to start the registration
process, you can press < at any time
to stop the search.
When the S1000 is found by the
SmartController and registration is
complete, the display will read REGISTERED
Note: For successful registration, ensure that all other handheld units on
your boat are turned off. If you try to register a new handset with others ac-
tive, you will see a REGISTRATION INCOMPLETE message.
To de-register a handset
In the DEALER menu, at
REGISTRATION, press PILOT.
If the S100 is already registered, then
the display will read REGISTERED. Press > to continue, or STANDBY to
cancel the operation.
The S100 will attempt to communicate with the S1000 and de-register.
When complete, the display will read NOT REGISTERED.
If the S100 cannot communicate with the S1000 then a BASE NOT FOUND
message will be displayed. It is still possible to de-register the S100 at this
point by pressing >. To leave without de-registering, press STANDBY.
Factory Reset
This option will clear all settings from the S100 and the S1000. Press and
hold the PILOT key for 2 seconds to activate the reset.
Note: A reset does not alter the registration status of the S100
REGISTER
START >
HANDSET NOT
REGISTERED
REG >
SEARCHING
D7657-1
< CANCEL
REGISTERED
DE-REG >
D7674-1