Filter
Top Products
User Guide 19
Setting up the autopilot
Quick Tip
Before you use your S1000 autopilot for the first time, you will need to
run through the automatic configuration utility - AutoLearn.
AutoLearn requires a significant amount of CLEAR SEA SPACE in
front of your boat. It will take your boat through a series of zig-zag
manouvers until it has acquired enough data. If you need to cancel
AutoLearn at any time, press STANDBY to gain manual control.
1. Press and hold STANDBY for
2 seconds to enter PILOT SETUP
mode.
2. Press mode until the display
reads AUTOLEARN
3. Press the PILOT key to activate
AUTOLEARN.
For best results, perform AUTOLEARN whilst
steering INTO wind and waves.
At least 0.25 nm
(500 m
) of clear
sea space
At least 0.04 nm
(100
m
)
of clear sea space
1 minute
(approximately)
Wind
press and hold
Pilot Setup
AUTOLEARN
MODE
STANDBY
press to start
AutoLearn procedure
3
1
2
D7651-1
PILOT