Filter
Top Products
44
© 2006 directed electronics—all rights reserved
and the battery is disconnected for any reason, such as servicing the
car, when the battery is reconnected the unit will still be in Valet
Mode. This applies to all states of the system including arm, disarm,
and Valet Mode.
power saver mode
Your system will automatically enter Power Saver Mode while armed
or in Valet Mode, after a period of time in which no operation has
been performed. This lowers the current draw on the vehicle's battery.
Power Saver Mode takes over under the following conditions:
➤ Power Saver when the system is armed: After the system
has been armed for 24 hours the LED will flash at half its
normal rate, decreasing the system's current draw.
➤ Power Saver in Valet Mode: When the system enters Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a one hour period while the
system is in Valet Mode, the LED will shut off. If the system
remains in Valet Mode, the LED will come back on the next
time the ignition is turned on and then back off.