Filter
Top Products
12
© 2006 directed electronics—all rights reserved
Note: If the remote control does not play the transmitting anima‑
tion, the remote control did not transmit the command.
•
Command response: one second after the system receives
and implements a command; it will transmit a command response
to the activating remote control. The remote control will play the
appropriate Notification output.
Note: If more than one remote control is programmed to the
system, a command update will follow ten seconds later.
•
Command Update: a command update is sent to keep
additional remote controls in sync with the current system state.
The command update remote control Notification will be a
repeat of the command response.
Note: If only one remote control is programmed to the system, a
command update IS NOT sent.
•
Page: a Page is a single transmission five seconds long to
all programmed remote controls.
A page is transmitted when the system state changes by means
other than a command from a remote control. Usually it is due to
an alarm warn or full trigger, a timer mode remote start, a remote
start shutdown, or the Car Call feature is activated.
•
Notification: a remote control Notification is the audible
beeps and animation output after the remote control receives
a command response, command update, or a page from the
system.