Python 1090 Automobile Alarm User Manual


 
35
© 2006 directed electronics—all rights reserved
there may be a delay for the glow plugs to warm.
e. The engine can be turned off via remote control at this time
without exiting timer mode. If not turned off, the engine
will run for the programmed run time and will restart every
three hours for 18 hours.
note: if programmed to temperature timer mode, the
remote start will check the temperature every three hours,
and will only start if the temperature is below 0 degrees F.
remote” The remote control Notification will be two beeps
ascending in tone followed by the remote start animation.
to exit timer mode
a. With engine off, turn the ignition to the on position.
b. Step on the brake
c. Open the hood
d. Toggle the shutdown switch to off
The lights will flash four times to confirm timer mode has been
exited.
remote” There is no remote control Notification for exiting
timer mode unless remote start is active at the time. If active,
the engine off Notification will be played.
rear defogger
This system includes an output that can be programmed to automati-
cally activate the vehicle rear window defogger when remote started.