Filter
Top Products
26
© 2006 directed electronics—all rights reserved
➜
disarming without a remote control
If your remote control should be lost, damaged or fail to operate
the system, the ignition and Valet Switch can be used to disarm the
alarm.
You must know where the Valet Switch is located and the correct
number of presses required for the alarm to disarm.
Have your installer familiarize you with this procedure. The siren will
be sounding while you are disarming which can be quite distracting.
1. Open the driver’s door and enter
the vehicle.
2. Turn the ignition to the on posi
-
tion
3. Within 5 seconds press and release
the Valet Switch the correct number
of times
4. 3 seconds later the alarm will
disarm and the siren will turn off. If
the alarm fails to disarm, return to
step 2 above.
note: 1 press is the default number of valet switch presses
required to disarm the alarm. Your installer can program 2-5
presses if desired.
NUMBER OF PRESSES______________________________
VALET SWITCH LOCATION________________________
DRW-35