Filter
Top Products
181
Appendix
(6) “Direction of G sensor is not correct. Please turn off the system and check the instal-
lation. After you have checked, please re-boot the system and press “OK”.”
When:
Direction of G sensor is set incorrectly.
What to do:
See the “Installation Manual” and set the direction of G sensor correctly.
(7) “Gyro Sensor is not working properly. Please consult your dealer or Pioneer service
center.”
When:
Abnormal output of Gyrosensor is detected.
What to do:
Note down the error code shown on the screen; turn off the power, and then contact your nearest Pioneer
service facility.
(8)“Your route could not be found.”
When:
If the distance to the destination is too far and cannot be set.
What to do:
Change the destination to a location that is closer and divide up the route.
(9)“You cannot set additional way points. Please cancel current way point and re-enter
to set new way point.”
When:
If you try to set more than five way points.
What to do:
Add the next way point after arriving at your first way point. Or, after deleting an unnecessary way point,
add a new way point.
(10)“Your journey cannot avoid the specified area.”
When:
If route setting cannot avoid a specified Area to Avoid.
What to do:
Choose whether or not to try setting a route through the area.
(11)“More than 6 characters are required.”
When:
If you enter a name of six characters or less for a registered location or a listing in the Address Book.
What to do:
Use a name with more than six characters.
(12)“Memory Full.”
When:
If there are already 300 items items when you attempt to register an item in the Address Book.
What to do:
Delete some destinations as appropriate.