Filter
Top Products
117
Chapter 6
Combining and Using Pioneer AV Equipment
TUNER
These are the basic steps necessary to operate the radio. More advanced tuner operation is
explained starting on page 118.
➲ This cannot be used unless AV Head Unit is combined and the source unit is connected by
IP-BUS.
BAND
Shows which band the radio is tuned to AM or FM.
FREQUENCY
Shows to which frequency the tuner is tuned.
PRESET NUMBER
Shows what preset has been selected.
STEREO indicator
Shows that the frequency selected is being broadcast in stereo.
LOC indicator
This is indicated unless local seek turning is turned OFF.
■How to listen to the radio
1Press SOURCE button to select the tuner.
2 Use VOL dial to adjust the sound level.
Rotate to increase or decrease the volume.
3Press BAND/ESC button to select a band.
Press BAND/ESC button until the desired band is displayed, FM 1, FM 2, FM 3 for FM
or AM.
4To perform manual tuning, press
22
22
or
33
33
with quick presses.
The frequencies move up or down step by step.
5To perform seek tuning, press and hold
22
22
or
33
33
for about one second and release.
The tuner will scan the frequencies until a broadcast strong enough for good reception is
found.
➲ You can cancel seek tuning by pressing either 22
22
or 33
33
with a quick press.
➲ If you press and hold 22
22
or 33
33
you can skip broadcasting stations. Seek tuning starts as
soon as you release the buttons.
1 23
NAVI/AV
button
N/A
4
5
1
2
3
4
5