Filter
Top Products
E-Maxx
•
7
Quick Start: Getting up to Speed
The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom
corners of Quick Start pages.
1. Read the safety precautions on page 4 9. Detail your model • See page 8
For your own safety, understand where carelessness and misuse
could lead to personal injury.
Apply other decals if desired.
2. Charge the battery packs • See sidebar, page 12 10. Drive your model • See page 17
Fully charge two 7.2 or 8.4-volt battery packs (not included). Charge your
batteries now so it will be ready when you finish the other setup procedures.
Driving tips and adjustments for your model.
3. Install the antenna • See page 11 11. Maintaining your model • See page 25
Install the antenna mast in the model. Follow these critical steps to maintain the performance
of your model and keep it in excellent running condition.
4. Install batteries in the transmitter • See page 11
The transmitter requires 8 AA alkaline or rechargeable batteries.
5. Install battery packs in the model • See page 12
Your model requires two fully charged 7.2 or 8.4-volt battery packs
(not included).
6. Turn on the radio system • See page 14
Make a habit of turning the transmitter on rst, and off last.
7. Check servo operation • See page 14
Make sure the steering servos are working correctly.
8. Range test the radio system • See page 14
Follow this procedure to make sure your radio system works properly
at a distance and that there is no interference from outside sources.
The Quick Start Guide is
not intended to replace the
full operating instructions
available in this manual.
Please read this entire
manual for complete
instructions on the proper
use and maintenance of
your model.
Look for the Quick Start
logo at the bottom of
Quick Start pages.