Filter
Top Products
16
•
E-Maxx
Patent Pending Training
Mode (Prole #3) reduces
forward and reverse throttle
by 50%. Training Mode
is provided to reduce the
power output allowing
beginning drivers to better
control the model. As driving
skills improve, simply change
to Sport or Race Mode for
full-power operation.
Thermal Shutdown Protection
The EVX-2 is equipped with thermal shutdown protection to guard
against overheating caused by excessive current ow. If the operating
temperature exceeds safe limits, the EVX-2 will automatically shut
down and the EVX-2 LED will ash red. The LED on the face of the EVX-
2 will continuously ash red, even if the throttle trigger is moved back
and forth. After the speed control cools down to a safe level,
the LED will continuously shine green. The EVX-2 will once again
function normally.
EVX-2 Prole Selection
The speed control is factory set to Prole #1. To change the prole,
follow the steps on described below. The speed control should be
connected to the receiver and battery, and the transmitter should be
adjusted as described previously. The proles are selected by entering
the programming mode.
EVX-2 Prole Description
Prole #1 (Sport Mode): 100% Forward, 100% Brakes, 100% Reverse
Prole #2 (Race Mode): 100% Forward, 100% Brakes, No Reverse
Prole #3 (Training Mode): 50% Forward, 100% Brakes, 50% Reverse
Selecting Sport Mode (Prole #1)
1. Connect two fully charged battery
packs to the EVX-2 and turn on your
transmitter.
2. With the EVX-2 off, press and hold
the EZ-Set button until the light
turns solid green, then solid red and
then begins blinking red (indicating
the Prole numbers).
3. When the light blinks red once,
release the EZ-Set button.
4. The light will then turn green and the model is ready to drive.
Selecting Race Mode (Prole #2)
1. Connect two fully charged battery
packs to the EVX-2 and turn on your
transmitter.
2. With the EVX-2 off, press and hold
the EZ-Set button until the light
turns solid green, then solid red and
then begins blinking red (indicating
the Prole numbers).
3. When the light blinks red twice,
release the EZ-Set button.
4. The light will then turn green and the model is ready to drive.
Selecting Training Mode* (Prole #3)
1. Connect two fully charged battery
packs to the EVX-2 and turn on your
transmitter.
2. With the EVX-2 off, press and hold
the EZ-Set button until the light
turns solid green, then solid red and
then begins blinking red (indicating
the Prole numbers).
3. When the light blinks red three
times, release the EZ-Set button.
4. The light will then turn green and the model is ready to drive.
Note: If you missed the mode you wanted, keep the EZ-Set button
pressed down and the blink cycle will repeat until a Mode is selected.
B
One blink Red
A
Green to Red to Off
D
Solid Green
C
Release
Adjusting the Electronic Speed Control
Tip For Fast Mode Changes
The EVX-2 is set to Prole 1
(Sport Mode) as the default.
To quickly change to Prole 3
(Training Mode), with the
transmitter on, press and hold
the SET button until the light
blinks red three times and then
release. For full power, quickly
change back to Prole 1 (Sport
Mode) by pressing and
holding the SET button until
the light blinks red one time
and then releasing.
B
Two blinks Red
A
Green to Red to Off
D
Solid Green
C
Release
B
Three blinks Red
A
Green to Red to Off
D
Solid Green
C
Release
*Patent-pending