Filter
Top Products
Trekker - Squab
REMOVAL
6
64765
752026
68007
750806
Removal of the engine
- Remove :
- All side casings
- Disconnect :
- Fuel line from the carburettor,
- Fuel tap vacuum hose,
- Oil pump control cable
- Throttle control cable,
- Oil iniet piping at the pump (large
hose)
- Radio interference suppressor cap
- Rear brake control cable
Disconnect :
- The wiring harness on the frame’s
right tube: located at the outlet of the
Flywheel magneto (under the foot
board), choke, starter motor.
Remove :
- The lower anchor bolt of the shock
absorber and the front anchor pin of
the engine.
Removal of the flywheel
magneto
- Block the rotor using a notch type pin
752237.
- Remove the nut (right-hand thread).
- Fit the crankshaft end protector
68007 onto the end of the crankshaft.
- Screw the flywheel puller tool 750806
onto the rotor and tighten the centre
bolt until the rotor comes away.
- Remove the 2 fastening screws of
the sensor, as well as the 2 fastening
screws of the stator plate.
- Remove the coil assembly and the
sensor.
Removal of cooling
systern
- Remove the two parts of the fan
covers (4 screws).
- Remove the 4 fastening screws of
the fan and remove the fan.
Fitting of engine on service
cradle
- Place the engine onto the adapter
752026
- Place the assembly on the cradle
mount 64765 clamped in a vice