Filter
Top Products
Trekker - Squab
INSTRUCTIONS FOR MAKING OPERATIONAL
4
1. Preparation of the battery
(dry charged)
- Remove the battery.
- Remove the six cell caps and the breather tube cap.
- Fill the battery with électrolyte up to the level marked
UPPER LEVEL (35% sulphuric acid 1.28 g/CM3),
Ref :........................................................... 1 litre : 752740
................................................................ 5 litres : 752741
- Leave the battery to settle for half an hour. Top up the
level if necessary.
- Charge the battery for 1 to 2 hours with a current of
400m.A (0.4A).
- Replace the battery and connect the breather tube.
- Connect up the red positive leads to the battery positive
terminal, then the green negative lead to the battery earth
terminal.
- From then on, the battery can be topped up if necessary,
using distilled water only.
2. Fuel
Capacity : .............................................................. 6 litres
- Conventional 4-star petrol.
- Lead free petrol 98 octanes.
3. Separate lubrication:
Capacity : .......................................................... 1.3 litres.
- Fill up the oil tank with semi-synthetic engine oil for 2-
stroke engines with separate lubrication,
- Type TC (API standard), type TSC3 (ASTM standard), -
- Type FC (JASO standard) or a synthetic oil.
PEUGEOT MOTOCYCLES recommends :
.......................................ESSO : 2T Special performance
......................................................... ESSO : 2T Synthetic
4. Putting fuel and oil circuits into
opération:
- Put one litre of fuel mixture with 4% oil into the fuel tank.
- Fill up the oil tank.
- Start the engine: make sure that the oil circuit is
completely primed. Remove the oil bleed screw from the
pump to allow air in the circuit to escape. When a
continuons stream of oil issues from this hole, replace the
bleed screw with its fiber washer.
For this : disconnect the oil intake hose to the carburettor
and check that it drips, frequency depending on the
engine’s speed.
- Top up the fuel tank with pure 4 star petrol.
5. Checking the oil level in the
transmission case:
- Unscrew and remove the oil filler hole screw A and
make sure that the oil level is flush with the level of the
filling hole. The vehicle must be positioned on its stand
and on a level surface.
Esso Oil SAE 80 W 90
REF : .................................................................... 753009
capacity 0. 1 2 litre
A = 1.2m.daN.
6. Checks before delivery to the
customer:
- In particular, check the tightening of the Wheel nuts ... -
front : .................................................................... 6m daN
- rear :.............................................................. 1Om daN
- Check the tightness of the nuts and bolts.
- Check brake adjustment and eff iciency.
- Cold tyre pressure:
FRONT
- pressure : ......................................................... 1.3 bar
- size : .......................................................... 120/90 x 10
REAR
- pressure : ......................................................... 1.6 bar
- size : .......................................................... 130/90 x 10
- Make sure all lights and signals operate correctly
(taillight, turnsignals, stop light, horn), and various
warning lights.
- vehicle road test.