Filter
Top Products
User’s Manual NAVIGON 2100 | 2110 max
Operating the NAVIGON 2100 | 2110 max - 17 -
GPS
The GPS icon is visible only in the navigation application. It can indicate
the following GPS reception states:
No GPS (No symbol): The built-in GPS receiver is not operational.
Contact customer service if the problem persists.
No Signal: Data is being received from less than three satellites.
Position cannot be calculated.
GPS Ready: Data is being received from at least three satellites. The
position of the vehicle can be calculated.
For details of the GPS status refer to chapter "GPS Status, saving the
current location"
on page 44.
Compass
The Compass icon is visible only in the navigation application. It shows
you in which direction you are currently moving. It can indicate the
following points of the compass: N, NE, E, SE, S, SW, W, NW.
TMC (Traffic Information)
The NAVIGON 2100 | 2110 max has an integrated TMC receiver which
provides the navigation system with traffic information updates. If
necessary it can change your route dynamically, for example in order to
avoid a traffic jam.
Note: This function is only available if TMC traffic messages are being
transmitted in the country in which you are travelling. This is not the
case in all countries.
The TMC icon is visible only in the navigation application. It can indicate
the following TMC reception states:
Tuning: The TMC receiver is operational but cannot find a station that
is transmitting TMC signals. There are no active traffic messages.
Tuning: The TMC receiver is operational but cannot find a station that
is transmitting TMC signals. Traffic messages are active however. This
can be the case, for example, when travelling through a tunnel.
TMC on Standby: Traffic messages can be received.
Note: The TMC antenna is integrated in the car charger cable. The
Tuning icon may still appear therefore when the car charger cable is
not connected to the NAVIGON 2100 | 2110 max.