Filter
Top Products
168
Controls in detail
Control system
If conditions have occurred causing status
messages to be recorded, the number of
messages appears in the multifunction
display:
̈ Press button k or j.
The stored messages will now be
displayed in the order in which they
have occurred. For malfunctions and
warning messages, see “Vehicle status
messages in the multifunction display”
(
୴ page 449).
Should the vehicle’s system record any
conditions while driving, the number of
messages will reappear in the multifunc-
tion display
ț when the SmartKey in the starter
switch is turned to position 0 or
removed from the starter switch.
or
ț when you turn off the engine by
pressing the KEYLESS-GO* start/stop
button (
୴ page 69) in the starter
switch once and open the driver’s door
(this puts the starter switch in
position 0, same as with the SmartKey
removed from the starter switch)
Settings menu
In the
Settings
menu there are two
functions:
ț The function
Reset to factory
settings?
, with which you can reset all
the settings to the original factory
settings.
ț A collection of submenus with which
you can make individual settings for
your vehicle.
̈ Press button è or ÿ repeatedly
until the
Settings
menu appears in the
multifunction display.
i
After you have scrolled through all recorded
status messages, the first recorded message
appears again.
i
The vehicle status message memory will be
cleared when you turn the SmartKey in the start-
er switch to position 1 or 2, or when you press
the KEYLESS-GO* start/stop button once or
twice without depressing the brake pedal. You
will then only see high priority messages in the
multifunction display (
୴ page 449).
164.boo Seite 168 Freitag, 30. März 2007 12:54 12