Filter
Top Products
145
Controls in detail
Lighting
When the engine is running, the low
beam headlamps, the tail and parking
lamps, the license plate lamps, and the
side marker lamps will switch on and
off depending on the brightness of the
ambient light.
Daytime running lamp mode
In Canada the daytime running lamp mode
is mandatory and therefore in a constant
mode.
In the USA the daytime running lamp mode
is deactivated by default. Activate the day-
time running lamp mode using the control
system, see “Setting daytime running lamp
mode (USA only)” (
୴ page 175).
̈ Turn the exterior lamp switch to
position M or U.
When the engine is running, the low
beam headlamps are switched on.
In low ambient light conditions, the
following lamps will switch on
additionally:
ț Tail and parking lamps
ț License plate lamps
ț Side marker lamps
Canada only
When the engine is running, and you shift
from a driving position to position N or P
with the vehicle at a standstill, the low
beam headlamps will switch off with a
three-minute delay.
When the engine is running, and you
ț turn the exterior lamp switch to
position C, the low beam head-
lamps, the tail and parking lamps, the
side marker lamps and the license
plate lamps switch on
ț turn the exterior lamp switch to
position B, the manual headlamp
mode has priority over the daytime
running lamp mode
USA only
i
Canada only:
High beam headlamps are only available with the
exterior lamp switch in position B.
i
With the daytime running lamp mode
activated and the engine running, you cannot
switch off the low beam headlamps manually.
i
With the exterior lamp switch in
position M or U, you cannot switch on the
high beam headlamps.
The high beam flasher is available at all times.
For nighttime driving turn the exterior lamp
switch to position B to permit activation of
the high beam headlamps.
i
With the exterior lamp switch in
position M, you cannot switch on the high
beam headlamps.
The high beam flasher is available at all times.
For nighttime driving turn the exterior lamp
switch to position B or U to permit
activation of the high beam headlamps.
164.boo Seite 145 Freitag, 30. März 2007 12:54 12