Filter
Top Products
51
Getting started
Driving
Windshield wipers
The combination switch is located on the
left of the steering column.
Combination switch
1 Single wipe
Wiping with windshield washer fluid
2 Switching on windshield wipers
̈ Switch on the ignition (୴ page 32).
Switching on windshield wipers
̈ Turn the combination switch to the
desired position depending on the
intensity of the rain.
0 Windshield wipers off
I Intermittent wiping
II Normal wiper speed
III Fast wiper speed
Intermittent wiping
Vehicles with rain sensor*:
Intermittent wiping interval is dependent
on wetness of windshield.
̈ Turn the combination switch to
position I.
Vehicles with rain sensor*:
After the initial wipe, pauses between
wipes are automatically controlled by
the rain sensor.
i
If the combination switch is pressed to the
point of resistance and released, the
corresponding turn signals will flash three times.
!
Do not operate the windshield wipers when
the windshield is dry. Dust that accumulates on
a windshield might scratch the glass and/or
damage the wiper blades when wiping occurs on
a dry windshield. If it is necessary to operate the
windshield wipers in dry weather conditions, al-
ways operate the windshield wipers with wind-
shield washer fluid (
୴ page 52).
!
Vehicles with rain sensor*:
Do not leave windshield wipers in intermittent
setting when the vehicle is taken to an automatic
car wash or during windshield cleaning. Wind-
shield wipers will operate in the presence of wa-
ter sprayed on the windshield, and windshield
wipers may be damaged as a result.
!
Vehicles with rain sensor*:
If you have set intermittent wiping, dirt on the
surface of the rain sensor or optical effects may
cause the windshield wipers to wipe in an undes-
ired fashion. This could then damage the wind-
shield wiper blades or scratch the windows. You
should therefore switch off the windshield wip-
ers when weather conditions are dry.