Filter
Top Products
222
Controls in detail
Power windows
Opening the windows
̈ Press switch 1 to 4 to the resistance
point.
The corresponding window will move
downwards until you release the
switch.
Closing the windows
̈ Pull switch 1 to 4 to the resistance
point.
The corresponding window will move
upwards until you release the switch.
Fully opening the windows
(Express-open)
̈ Press switch 1 to 4 past the
resistance point and release.
The corresponding window opens
completely.
Fully closing the windows
(Express-close)
̈ Pull switch 1 to 4 past the
resistance point and release.
The corresponding window closes
completely.
Stopping windows
̈ Press or pull respective switch again.
Synchronizing power windows
The power windows must be
resynchronized each time
ț after the battery has been
disconnected or discharged.
ț if the power windows cannot be fully
opened (Express-open) or closed
(Express-close).
̈ Switch on the ignition (୴ page 32).
Warning! G
If you pull and hold the switch up when
closing the window, and upward movement
of the window is blocked by some obstruc-
tion including but not limited to arms, hands,
fingers, etc., the automatic reversal will not
operate.
!
If the upward movement of the window is
blocked during the closing procedure, the win-
dow will stop and open slightly.
Remove the obstruction, pull the switch again
past the resistance point and release.
If the window still does not close when there is
no obstruction, then pull and hold the switch
again. The side window will then close without
the obstruction sensor function.
Warning! G
Driver’s door only:
If within 5 seconds you again pull the switch
past the resistance point and release, the
automatic reversal will not function.