Filter
Top Products
379
Practical hints
Flat tire
1 Take-up bracket
2 Jack
̈ Place jack 2 on firm ground.
̈ Position jack 2 under take-up
bracket 1 so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an
incline.
̈ Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while
vehicle is raised.
Removing the wheel
1 Alignment bolt
̈ Unscrew upper-most wheel bolt and
remove.
̈ Replace this wheel bolt with alignment
bolt 1 supplied in the tool kit.
̈ Remove the remaining bolts.
̈ Remove the wheel.
Warning! G
The jack is intended only for lifting the
vehicle briefly for wheel changes. It is not
suited for performing maintenance work
under the vehicle.
ț Never start the engine when the vehicle
is raised.
ț Never lie down under the raised vehicle.
!
Do not place wheel bolts in sand or dirt. This
could result in damage to the bolts and wheel
hub threads.