Filter
Top Products
387
Practical hints
Jump starting
The battery is located in the engine
compartment on the right hand side. The
terminals for jump starting are located in
front of the battery.
̈ Make sure the two vehicles do not
touch.
̈ Turn off all electrical consumers.
̈ Apply the parking brake (୴ page 54).
̈ Make sure the gear selector lever* is
set to position P (
୴ page 153) (manual
transmission: to Neutral (
୴ page 149)).
̈ Open the hood (୴ page 274).
̈ Flip up cover from the positive under
hood terminal 2 in front of the filter
box (
୴ page 383).
1 Positive terminal of charged battery
2 Positive under hood terminal in front of
discharged battery
3 Negative under hood terminal in front
of discharged battery
4 Negative terminal of charged battery
̈ Connect positive terminal 1 of the
charged battery with positive under
hood terminal 2 in front of the filter
box with the jumper cable. Clamp cable
to charged battery 1 first.
̈ Start engine of the vehicle with the
charged battery and run at idle speed.
̈ Connect the negative terminal 4 of
the charged battery with the negative
under hood terminal 3 in front of the
filter box with the second jumper cable.
Clamp cable to charged battery 4
first.
̈ Start the engine of the disabled
vehicle.
You can now turn on the electrical con-
sumers. Do not switch on the headlamps
under any circumstances.
̈ Remove the jumper cables first from
the negative terminals 3 and 4 and
then from the positive terminals 2
and 1.
You can now switch on the headlamps.
̈ Have the battery checked at the near-
est authorized Mercedes-Benz Center.
!
Never invert the terminal connections!